Marlin 1894 Pad dimensions

deerwhacker444 · Post by **deerwhacker444** » Fri May 23, 2008 12:37 pm

.
Since I'm at work, would one of you be so kind as to measure your Marlin 1894 and tell me which pad I need. I want it to be a bit larger than the stock so I can grind it down to fit. I'm going to lengthen the pull a bit.

envisaged · Post by **envisaged** » Fri May 23, 2008 12:41 pm

1. 4 13/16"

envisaged · Post by **envisaged** » Fri May 23, 2008 12:42 pm

2. 1 5/8"

envisaged · Post by **envisaged** » Fri May 23, 2008 12:43 pm

3. 3 1/8"

Edit: center to center of screw is 2 13/16".

envisaged · Post by **envisaged** » Fri May 23, 2008 12:45 pm

4. 7/8"

Note these measurements are not to the center of the screws but to the far edge.

envisaged · Post by **envisaged** » Fri May 23, 2008 12:46 pm

5/6. 1/4"

This is a 1894 Marlin Cowboy special in .357 mag.

deerwhacker444 · Post by **deerwhacker444** » Fri May 23, 2008 12:48 pm

Thanks..!

meanc · Post by **meanc** » Fri May 23, 2008 2:00 pm

Just to let you know, that if you order a new pad from Marlin, it will be larger and require final fitting to your gun.