Buttstock 1963 M94
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Buttstock 1963 M94
Do any of you fellers know if the butt of the stock on a 1963 model 94 was flat or slightly curved? I'm asking because mine has a Pacmayr White Line pad installed and I was thinking about getting an original plate for it, if it will fit. Mine has a straight cut on it. I took the Pacmayr off to look underneath and don't see any saw marks or numbers. Should these have a model number stamped into the butt? I'd be much obliged for any info on this.
We the people are the Rightful Masters of both Congress and the Courts. Not to overthrow The Constitution but to overthrow the men who pervert The Constitution.
Abraham Lincoln
Abraham Lincoln
-
Shasta
- Senior Levergunner
- Posts: 1577
- Joined: Thu Sep 06, 2007 10:50 pm
- Location: Shasta County, the far right stronghold in California
Re: Buttstock 1963 M94
On page 88 of Renneberg's book Winchester Model 94 it states post-war guns serial numbered 1,350,000 to 3,500,000 had a flat steel checkered buttplate. Later examples had a flat buttplate made of plastic with a Winchester logo.
The accompanying photos show a flat surface with no curvature.
SHASTA
The accompanying photos show a flat surface with no curvature.
SHASTA
California Rifle & Pistol Association LIFE Member
National Rifle Association BENEFACTOR LIFE Member
http://www.hcrpclub.org/schedule.html
avatar pic is Shasta Dam, Shasta Lake, & Mt. Shasta
National Rifle Association BENEFACTOR LIFE Member
http://www.hcrpclub.org/schedule.html
avatar pic is Shasta Dam, Shasta Lake, & Mt. Shasta
Re: Buttstock 1963 M94
I sure do appreciate it SHASTA. I see Butt Plates on ebay from time to time, but most have a slight curve. I reckon I'll keep lookin. I just didn't want to buy one and have it not fit because the butt had been sawed off to fit the Pacmayr.
We the people are the Rightful Masters of both Congress and the Courts. Not to overthrow The Constitution but to overthrow the men who pervert The Constitution.
Abraham Lincoln
Abraham Lincoln
Re: Buttstock 1963 M94
That is the chance You are going to have to take if You want to change it. Other than doing detailed measurements of course.wfo wrote:I sure do appreciate it SHASTA. I see Butt Plates on ebay from time to time, but most have a slight curve. I reckon I'll keep lookin. I just didn't want to buy one and have it not fit because the butt had been sawed off to fit the Pacmayr.
Perry
Perry in Bangor----++++===Calif