Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
If you have a factory barrel it's pretty simple . When you open the action you wil see that the barrel screws in till it's flush with the inside of the receiver with the ejector groove at the top. Use a empty cartridge with a couple layers of masking tape to check the head space. The action should close with two layers but not 3 . Your looking I believe max of .007 of an inch. Make sure the bolt is open or out so you don't break off the extractor.
The "problem" I see for you is that the .32 WS barrel you're likely to find will be for the standard carbine but the Ted Williams has a different front sight/magazine set up. You might have to change that as well. IOW, you'll be making a standard 94 carbine out of it.
Sincerely,
Hobie
"We are all travelers in the wilderness of this world, and the best that we find in our travels is an honest friend." Robert Louis Stevenson