Fed Ex on Sunday?

[GunnyMack]

Just heard a loud THUMP , since the weatherliars have been saying Tstorms I thought it was about to open up. So I looked out the window and see the Fed Ex truck.
Now what did he bring? Oh yes that's right! Scott T sent me his Lyman turret press.

20240630_152153.jpg

Now I have to dismount my RCBS, layout for the Lyman holes and D&T 3/8-16. My bench top is 3/4 " plywood that I've mounted 1/2" steel plates . The plates allow me to swap presses, trimmers at whim and not worry about tearing up the plywood.
Hopefully one of the RCBS holes will work , saving me a little effort!
Scott, again many thanks !

[Scott Tschirhart]

Use it in good health my friend.

[GunnyMack]

Thank you Scott, it will certainly have a good home here.

The thunderstorms are here!
The plate has been drilled and tapped.

20240630_165921.jpg

Once the eletric stuff passes I have to go out to the shop and grab my DeWalt cordless drill and drill counter bore holes in the plywood.
I realized I need to get a new 3/8-16 taper gun tap, this one is older than me and getting dull! ( like me )
Then I can mount the plate and swap between presses by turning a few screws.

[GunnyMack]

All mounted and ready to load some ammo!

20240630_173308.jpg

But first and foremost CLEAN UP!!

[AJMD429]

.
Cool setup, and nice to see stuff get kept in use and shared...

[Bill in Oregon]

Hey, Will, I can still see the top of your loading bench!

[GunnyMack]

That's only because I had to have room to work Bill!

[marlinman93]

Around here FedEx is delivered by USPS on Sundays. Not sure how USPS on overtime can deliver cheaper than FedUps employees?

[GunnyMack]

Same here, post office seems to get the Sunday deliveries.
What rubs me wrong is Midway ships UPS then hands off to USPS - that's when stuff slows down or goes missing!