Hi,
The rear pin in the bolt seems to be pointed down too far and the firing pin doesn't hit the primer hard enough. I've never done anything to the spring.
I took the extractor and ejector out and the bolt won't close. About 1/4" short. I've never gone beyond taking the bolt out, even though I have directions. Other than an obstruction what else could it be? Update: the back rollpin protruded slightly, that is what prevented the bolt from going forward.
I plan on taking some guns to a smith so I will most likely let him worry about it. Still like to ask though.
Thanks.
Marlin 336RC misfires and now bolt won't close
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Marlin 336RC misfires and now bolt won't close
Last edited by ba_50 on Wed Jun 11, 2008 6:09 am, edited 1 time in total.
-
- Shootist
- Posts: 1682
- Joined: Sun Dec 09, 2007 7:46 pm
- Location: BLACK HILLS, DAKOTA TERRITORY
Re: Marlin 336RC misfires and now bolt won't close
IT'S BECAUSE YOU DO NOT HAVE THE HENWAY LINED UP CORRECTLY.
RIDE, SHOOT STRAIGHT, AND SPEAK THE TRUTH
-
- Levergunner 2.0
- Posts: 387
- Joined: Fri Apr 06, 2007 10:26 pm
- Location: Lexington, NC
Re: Marlin 336RC misfires and now bolt won't close
What's a henway?
Re: Marlin 336RC misfires and now bolt won't close
Ed, Are you shooting reloads? If the sizing or seating isn't just right your bolt may not close without a little extra force. Disassembly is very easy. I'd try it before taking it to a smith. Did the gun just start doing this of late? Ammo brand? New bullet? Will it close without a round inthe chamber? I've had similar issues and it was due to resizing.
TomF
TomF
-
- Levergunner 2.0
- Posts: 387
- Joined: Fri Apr 06, 2007 10:26 pm
- Location: Lexington, NC
Re: Marlin 336RC misfires and now bolt won't close
I'm not the one having trouble. I just didn't want Terry's perfectly good setup hanging out there so long without a reply.
Re: Marlin 336RC misfires and now bolt won't close
Bout the same as a chicken.edwardyoung wrote:What's a henway?