Got home today from work and Turq is on the WRONG side of the gate! Huh, seems he has learned to climb up & over...little stinker!
So off to the shop, how am I going to foil him this time...
Light bulb sparked to 150 watts- a roller!
So I cut 2 pieces of aluminum angle to 1.5" , drilled a 1/4" hole on one side, 2 countersunk holes on the opposite side, found a hunk of 2" pvc pipe. 1.375 ID.
Now where is my fly cutter? On the drill press stand, where it's supposed to be! Couple fine tunings and some 1x pine has been cut to press fit the pipe. Now to dig up some bolts. Carriage bolts will do.
Back to the house, center the roller L to R, predrill the screws into the oak gate and its installed.
20230912_154657.jpg
You do not have the required permissions to view the files attached to this post.