Does anyone know where I can buy a 44 Mag (2019) - Rossi 92 Carbine Front Barrel/Magazine Ring Screw?
While taking my carbine completely apart for polishing, I could not easily remove the front ring screw and ruined the head by pure accident, thinking it was moving. I did get the screw out but really need a replacement, because of it.
Where can I buy one?
Rossi barrel/magazine ring screw
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
-
- Levergunner 2.0
- Posts: 141
- Joined: Tue May 19, 2020 10:58 am
- gamekeeper
- Spambot Zapper
- Posts: 17626
- Joined: Thu Sep 06, 2007 3:32 pm
- Location: Over the pond unfortunately.
Re: Rossi barrel/magazine ring screw
Our own Steve's Gunz should be my first call..
http://www.stevesgunz.com/
http://www.stevesgunz.com/
Whatever you do always give 100%........... unless you are donating blood.
Re: Rossi barrel/magazine ring screw
Those are impossible to find.
D. Brian Casady
Quid Llatine Dictum Sit, Altum Viditur.
Advanced is being able to do the basics while your leg is on fire---Bill Jeans
Don't ever take a fence down until you know why it was put up---Robert Frost
Quid Llatine Dictum Sit, Altum Viditur.
Advanced is being able to do the basics while your leg is on fire---Bill Jeans
Don't ever take a fence down until you know why it was put up---Robert Frost
Re: Rossi barrel/magazine ring screw
Failing the above recommendation, try M&M - http://mmgunsmith.com . While their advertised focus may be the old (Interarms) 92 Rossis, I'll bet they can help on this one... Can't imagine Rossi changing the screws out ... but you never know.
-
- Levergunner 2.0
- Posts: 141
- Joined: Tue May 19, 2020 10:58 am
Re: Rossi barrel/magazine ring screw
Thanks for all the suggestions and comments. I am looking at all my option and even thinking about making the screw myself.
Right now I have the measurements and know that the hole is tapped at #4-48 and a winchester 1970's screw with fit the threads. But, the length is long and the head is not just cylindrical but has a bottom taper to it. Just need the correct tap and die.
Again Thanks
Right now I have the measurements and know that the hole is tapped at #4-48 and a winchester 1970's screw with fit the threads. But, the length is long and the head is not just cylindrical but has a bottom taper to it. Just need the correct tap and die.
Again Thanks