crshelton same as crs

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
crshelton
Levergunner
Posts: 26
Joined: Fri Nov 10, 2017 2:58 pm

crshelton same as crs

Post by crshelton »

All,
After having no luck correcting recent problems with my original ID, crs, I set up a new one, crshelton (also used on some other forums) and now I will use crshelton unless something can be done to make my crs id work again.
Different id, same me. :wink:
Top
User avatar
vancelw
Advanced Levergunner
Posts: 3983
Joined: Mon Sep 28, 2009 1:56 pm
Location: 90% NE Texas and 10% SE Montana

Re: crshelton same as crs

Post by vancelw »

crshelton wrote: ↑Sun Nov 12, 2017 11:58 am All,
After having no luck correcting recent problems with my original ID, crs, I set up a new one, crshelton (also used on some other forums) and now I will use crshelton unless something can be done to make my crs id work again.
Different id, same me. :wink:
Maybe the CRS moniker was a self-fulfilling prophesy! :lol:

Maybe David or Paul can get you back in to your old account. I hate for you to have to start your post-count over....the horror :shock:
"Make yourself an honest man, and then you may be sure that there is one less scoundrel in the world." - Thomas Carlyle
Top
Leverluver
Senior Levergunner
Posts: 1000
Joined: Sat Sep 08, 2007 4:02 pm
Location: WY

Re: crshelton same as crs

Post by Leverluver »

That's what you get for being gone so long :mrgreen:
Top
Bill in Oregon
Advanced Levergunner
Posts: 10011
Joined: Sun Jun 29, 2008 10:05 am
Location: The Land of Enchantment

Re: crshelton same as crs

Post by Bill in Oregon »

Always nice to bump into you Charles, here or at Accurate Reloading.

8)
Top
Post Reply

Return to “General Discussion”