Rossi levergun sights

vanilla_gorilla · Post by **vanilla_gorilla** » Thu May 10, 2012 6:11 pm

Mine must have been put on by Jack Elam.

I honestly can't see any imaginable load that would cause POI and POA to be the same. Oh well. New, taller front sight, here I come.

Nate Kiowa Jones · Post by **Nate Kiowa Jones** » Fri May 11, 2012 12:13 am

If this a new round barrel carbine the problem is not the front. You need a lower rear. Rossi is now using a really tall semibuckhorn rear that won't go low enough to move POI down to POA.

vanilla_gorilla · Post by **vanilla_gorilla** » Fri May 11, 2012 7:30 am

New, octagon 24 inch rifle.

Is there an option for a slightly taller front sight? I will be replacing the rear with a folding sight to make room for my tang peep.

Washita · Post by **Washita** » Fri May 11, 2012 9:14 am

vanilla_gorilla wrote:New, octagon 24 inch rifle.

Is there an option for a slightly taller front sight? I will be replacing the rear with a folding sight to make room for my tang peep.

If you go with a tang sight, you probably won't need to change the front sight. I've put Marbles tang sights on several rifles, and didn't have to change the front sight on any of 'em.

Receiver peep sights. otoh, always seem to require taller front sights.

Rossi levergun sights

Rossi levergun sights

Re: Rossi levergun sights

Re: Rossi levergun sights

Re: Rossi levergun sights