Rossi R92-51500 Stainless Steel Finish

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
Frankdozer
Levergunner
Posts: 13
Joined: Tue Jan 25, 2011 7:56 am
Location: Maine

Rossi R92-51500 Stainless Steel Finish

Post by Frankdozer »

I just finished installing a new extractor in my Rossi R92-51011 357 stainless steel 24" barrel. It operates better than new. Touched up the action and it's not slick as snot but close. On the stainless steel receiver, there are microscopic fine scratches I'd like to remove. What is a good way to get the finish back to like new. I'm hesitant to use steel wool, sandpaper etc............But will if that's the general consensus. Thanks, Frank
Stay Thirsty My Friend
Top
stickfred
Levergunner 1.0
Posts: 82
Joined: Sun Jan 16, 2011 9:20 am
Location: N. West Virginia/Ohio Valley

Re: Rossi R92-51500 Stainless Steel Finish

Post by stickfred »

You'd probably be safe starting with a metal polishing paste/creme like Flitz, Mother's or something similar.
Top
Post Reply

Return to “General Discussion”