I am thinking around the primers this time because of the damp weather and long time storage. Anyone else do this ??
Jim
Sealing aroud a Primer Question
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
-
- Levergunner 2.0
- Posts: 124
- Joined: Thu Sep 04, 2008 2:56 pm
- Location: Texas
Re: Sealing aroud a Primer Question
Clear fingernail polish. No, I don't do it. Don't need to so far.
Sincerely,
Hobie
"We are all travelers in the wilderness of this world, and the best that we find in our travels is an honest friend." Robert Louis Stevenson
Hobie
"We are all travelers in the wilderness of this world, and the best that we find in our travels is an honest friend." Robert Louis Stevenson
- J Miller
- Member Emeritus
- Posts: 14906
- Joined: Sat Mar 31, 2007 7:46 pm
- Location: Not in IL no more ... :)
Re: Sealing aroud a Primer Question
I've done it in the past. More to identify what load was in the case or the brand of the primer rather than sealing the primer.
I used fingernail polish of various colors. What I found was that after it had set and dried for several years the polish flakes off. And when you shoot the round it goes everywhere. I don't know if this has any bearing on the sealing ability or not.
I do know that someone produces a bottle of sealer for primers and bullets. I can't remember their name, and I haven't used it.
Joe
I used fingernail polish of various colors. What I found was that after it had set and dried for several years the polish flakes off. And when you shoot the round it goes everywhere. I don't know if this has any bearing on the sealing ability or not.
I do know that someone produces a bottle of sealer for primers and bullets. I can't remember their name, and I haven't used it.
Joe
***Be sneaky, get closer, bust the cap on him when you can put the ball where it counts
.***

- marlinman93
- Advanced Levergunner
- Posts: 6917
- Joined: Sun Apr 01, 2007 3:40 pm
- Location: Oregon
Re: Sealing aroud a Primer Question
Never needed to seal them in my storage area. I've got rounds that were reloaded for ten years and shot like new.
Pre WWI Marlins and Singleshot rifles!
http://members.tripod.com/~OregonArmsCollectors/
http://members.tripod.com/~OregonArmsCollectors/
- AmBraCol
- Webservant
- Posts: 3781
- Joined: Fri Mar 30, 2007 8:12 am
- Location: The Center of God's Grace
- Contact:
Re: Sealing aroud a Primer Question
An old german I knew in Brazil as a kid used fingernail polish to seal around primers and the bullet/case neck as well. We worried a lot about humidity as one tends to do when the annual rain fall is measured in meters rather than inches and mould/mildew will grow on shoe soles if they're not worn on a regular basis. I don't know that it helped any, for the reasons mentioned above. It tends to dry up and flake off over time. Your best bet is to stock up on ammo cans and store ammo in them (novel concept there) and include a packet or so of gel desiccant in each can. I've stored ammo this way for years - decades even - and had no problems with it being surefire. If you load cast bullets then make sure you've plenty of lube around the bullet. It will naturally seal the bullet/case neck joint. And make sure each primer slides tightly into place - the friction fit is tight enough to keep out humidity for the most part. And if you store it in an airtight can with desiccant then you'll have surefire ammo for your grandkids to shoot up - as long as you use a good quality lube and not something that's going to migrate and contaminate the primers...
Paul - in Pereira
"He is the best friend of American liberty who is most sincere and active in promoting true and undefiled religion." -- John Witherspoon
http://www.paulmoreland.com
http://www.pistolpackingpreachers.us
http://www.precisionandina.com
"He is the best friend of American liberty who is most sincere and active in promoting true and undefiled religion." -- John Witherspoon
http://www.paulmoreland.com
http://www.pistolpackingpreachers.us
http://www.precisionandina.com
- Griff
- Posting leader...
- Posts: 21211
- Joined: Sat Mar 31, 2007 4:56 pm
- Location: OH MY GAWD they installed a STOP light!!!
Re: Sealing aroud a Primer Question
A nifty idea I've heard for over 30 years... yet to participate. Kinda like if all your friends tell you to jump from the Empire State Building... will ya? I know I can't fly, and my ammo gets rotated with uncertain regularity. (Translate that to mean I seldom have enough for my immediate needs.)
Griff,
SASS/CMSA #93
NRA Patron
GUSA #93
There is a fine line between hobby & obsession!
AND... I'm over it!!
No I ain't ready, but let's do it anyway!
SASS/CMSA #93
NRA Patron
GUSA #93
There is a fine line between hobby & obsession!
AND... I'm over it!!
No I ain't ready, but let's do it anyway!