Can a Win 94 locking lug be built up to adj. headspace?
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Can a Win 94 locking lug be built up to adj. headspace?
Can a Win 94 locking lug be built up to adj. headspace?
Kind regards,
Tycer
----------------------------------------------------------------
http://www.saf.org - https://peakprosperity.com/ - http://www.guntalk.com
Tycer
----------------------------------------------------------------
http://www.saf.org - https://peakprosperity.com/ - http://www.guntalk.com
Re: Can a Win 94 locking lug be built up to adj. headspace?
Yes. Mic uses Robar's NP3 plating to do just that. It can be applies in varying thickness. The bolt can also be treated to further decrease head space. It is very slick which is another benefit. Regards, 1886.
Re: Can a Win 94 locking lug be built up to adj. headspace?
Tycer,
When you say Win 94 do you mean the newer post 64 issue? If you are looking for headspace fix on an older pre64 you can purchase lugs oversize by .005, .010, and .015. I have done this on a 1917 Win. 1894 30-30. and it works well.
When you say Win 94 do you mean the newer post 64 issue? If you are looking for headspace fix on an older pre64 you can purchase lugs oversize by .005, .010, and .015. I have done this on a 1917 Win. 1894 30-30. and it works well.
regards
3T
3T
Re: Can a Win 94 locking lug be built up to adj. headspace?
3T is correct. The older 94s you could get various thickness for the Locking Bolt #5094 or #5194 complete. They usually have the thickness stamping on the Locking Bolt. 