I just picked up a nice 1921 M94 SRC, it still has the stud but is missing the ring. I can source a new ring, is there a proper way to install the new one or just bend it open and close it up?
thanks,
Rob
Proper way to in stall winchester saddle ring?
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
-
- Levergunner
- Posts: 3
- Joined: Fri Oct 04, 2019 10:26 am
Re: Proper way to in stall winchester saddle ring?
.
Welcome to the board, Rob !
If you haven't doe it before, it's fairly easy to kink the ring while working it.
I would cut to the chase, and simply install a replacement stud/ring assembly.
https://www.ebay.com/c/15012011116
If it appears to clash finish-wise with your rifle, it's easy enough to "antique" the replacement to match.
.
Welcome to the board, Rob !
If you haven't doe it before, it's fairly easy to kink the ring while working it.
I would cut to the chase, and simply install a replacement stud/ring assembly.
https://www.ebay.com/c/15012011116
If it appears to clash finish-wise with your rifle, it's easy enough to "antique" the replacement to match.
.