Rossi '92 Barrel
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
-
- Levergunner 1.0
- Posts: 69
- Joined: Fri Oct 05, 2007 12:24 pm
- Location: Sharpsburg, Maryland
Rossi '92 Barrel
I have an Interarms era '92 Trapper that's going to become a takedown. Anyone know whether these were metric or fractional pitch barrel threads? I hate to tear it down until I'm ready to start and finish the job - it just gets too much use. I'll be adding another barrel in .256 WM at the same time. It would be handy to know in advance as I've not cut metric pitch threads before with my old SB lathe. Thanks in advance!
-
- Shootist
- Posts: 1682
- Joined: Sun Dec 09, 2007 7:46 pm
- Location: BLACK HILLS, DAKOTA TERRITORY
-
- Advanced Levergunner
- Posts: 4923
- Joined: Sat Dec 22, 2007 1:08 am
- Location: Arizona headed for New Mexico
-
- Senior Levergunner
- Posts: 1521
- Joined: Sun Apr 15, 2007 12:52 am
- Location: Leverland, U.S.A.
- Contact:
Antietamgw,
I believe the barrel threads are METRIC.
The man to ask is Steve Young:
www.stevesgunz.com
He knows the Rossi 92 very well.
Shawn
I believe the barrel threads are METRIC.
The man to ask is Steve Young:
www.stevesgunz.com
He knows the Rossi 92 very well.
Shawn
"That's right, Billy, I'm good with it. I hit what I shoot at, and I'm fast!"-Lucas McCain, c1882.
-
- Site Sponsor
- Posts: 2507
- Joined: Fri Sep 07, 2007 12:05 pm
- Location: Lampasas, Texas
- Contact:
Re: Rossi '92 Barrel
I don't really know if they are metric or standard but IIRC the pitch is 1 in 27, an odd pitch. I do know that Rossi has used two different dia. for the barrel stubs. If you will email me I'll try to put a thread gage and mic on one to make sure.Antietamgw wrote:I have an Interarms era '92 Trapper that's going to become a takedown. Anyone know whether these were metric or fractional pitch barrel threads? I hate to tear it down until I'm ready to start and finish the job - it just gets too much use. I'll be adding another barrel in .256 WM at the same time. It would be handy to know in advance as I've not cut metric pitch threads before with my old SB lathe. Thanks in advance!
Steve Young aka Nate Kiowa Jones Sass# 6765
Steve's Guns aka "Rossi 92 Specialists"
205 Antler lane
Lampasas, Texas 76550
http://www.stevesgunz.com
Email; steve@stevesgunz.com
Tel: 512-564-1015
Steve's Guns aka "Rossi 92 Specialists"
205 Antler lane
Lampasas, Texas 76550
http://www.stevesgunz.com
Email; steve@stevesgunz.com
Tel: 512-564-1015