Search found 8 matches

by 1Winchester1
Wed Jan 27, 2021 2:32 pm
Forum: General Discussion
Topic: Weaver Model 94 Side Mount
Replies: 2
Views: 850

Weaver Model 94 Side Mount

Good Morning, trying to help my 81 year old uncle enjoy his pre -64 Model 94 again. He asked me to mount a Weaver side mount on it using existing holes. I bought the Model 3 D base from old stock as it is discontinued. The base fits fine, the issue is that the replacement screw that goes into the Fi...
by 1Winchester1
Mon Dec 28, 2020 11:06 am
Forum: General Discussion
Topic: Q: Win./Miroku 1895 Takedown in .30-06
Replies: 6
Views: 1646

Re: Q: Win./Miroku 1895 Takedown in .30-06

Ranger, I have the same Rifle possibly, Take down 3006 with Color Case. I have shot about 500 normal power loads without a hitch. I have hunted with this rifle several times and really enjoy it. I have the RCBS case gauge and the chamber is still extremely tight measuring my fired rounds as an indic...
by 1Winchester1
Tue Aug 13, 2019 1:31 pm
Forum: General Discussion
Topic: Model 88 .308 locked action
Replies: 4
Views: 726

Re: Model 88 .308 locked action

Mtn, I had the same problem with my Model 88. I was able to have it permanently repaired by Jim Dubell of Delta Gun shop. I had called around everywhere and someone referred me to Jim. He installed a pin at the rear of the action to compensate for some wear I believe. It has been fine (10 ) years no...
by 1Winchester1
Thu Jul 19, 2018 8:26 am
Forum: General Discussion
Topic: Rebounding Hammers
Replies: 13
Views: 2216

Re: Rebounding Hammers

Hawk, I appreciate the input. My takedown has never been apart, I have an RCBS Precision Mic and the headspace on fired cartridges is .001 over minimum. I only had one failure to fire out of 100 and it could have been a bad primer itself. I guess instant access to the issue on the internet and all I...
by 1Winchester1
Wed Jul 18, 2018 5:13 pm
Forum: General Discussion
Topic: Rebounding Hammers
Replies: 13
Views: 2216

Re: Rebounding Hammers

Good one. actually I have enough hardware in my leg to open a store. 6 screws ,4 pins and 2 plates.
by 1Winchester1
Wed Jul 18, 2018 1:25 pm
Forum: General Discussion
Topic: Rebounding Hammers
Replies: 13
Views: 2216

Re: Rebounding Hammers

Guys, Thanks for the replies. Since I removed the small amount from the rebounding leg, my primers look better. I am beginning to think that some of the issues are cause by the rust preventatives that the factory uses. The kids bought my rifle NIB as a birthday present for me but I believe that it w...
by 1Winchester1
Wed Jul 18, 2018 11:45 am
Forum: General Discussion
Topic: Rebounding Hammers
Replies: 13
Views: 2216

Re: Rebounding Hammers

Thank You, Griff
by 1Winchester1
Wed Jul 18, 2018 9:14 am
Forum: General Discussion
Topic: Rebounding Hammers
Replies: 13
Views: 2216

Rebounding Hammers

Good Morning men1 I have been reading this forum for years but have recently broken my leg severely and am stuck inside for 8 weeks( non weight bearing so confined to a walker). I have various Winchester and Browning lever actions, some original and some Miroku. My question is on my Miroku reproduct...